Compaq DS20E - AlphaStation - 1 GB RAM Průvodce řešením problémů stáhnout pdf (Strana 202)

10-16 DS20E Reference Guide

Compaq Confidential – Need to Know Required

Writer: Robert Young Project: AlphaServer DS20E System Comments:

Part Number: ER-K8F6W-UA .A01 File Name: k-ch10 Managing the System Remotely.doc Last Saved On: 10/4/99 1:33 PM

■

Switch 1 (EN RMC)—Set this switch to OFF (disable) if you want to

reset the baud rate of the COM1 port to a value other than the system

default of 9600. You must disable RMC to select a baud rate other than

9600.

■ Switch 3 (RPD DIS). Set this switch to ON (disable) if you want to

disable the poweroff command. With poweroff disabled, the monitored

system cannot be powered down from the RMC.

■ Switch 4 (SET DEF). Set this switch to ON (enable) if you want to

reset the RMC to the factory settings. See the section “Resetting the

RMC to Factory Defaults.”

Changing a Switch Setting

The RMC switches are numbered on the server feature module. The default

positions are shown in Figure 10-5. To change a switch setting:

Turn off the system.

1. Unplug the AC power cords.

NOTE: If you do not unplug the power cords, the new setting will not take effect when

you power up the system.

2. Remove the system covers.

3. Locate the RMC switch pack on the server feature module and change

the switch setting as desired.

4. Replace the system covers and plug in the power cords.

5. Power up the system to the SRM console prompt and type the escape

sequence to enter RMC command mode, if desired.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 299 300

Žádné komentáře

Compaq DS20E - AlphaStation - 1 GB RAM Průvodce řešením problémů Strana 202