Compaq DS20E - AlphaStation - 1 GB RAM Průvodce řešením problémů Strana 174
- Strana / 300
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
8-18 DS20E Reference Guide
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: Compaq AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA .A01 File Name: i-ch8 Installing Components.doc Last Saved On: 10/4/99 2:40 PM
Installing Storage Devices
The system unit is designed to accommodate up to four 1.6-inch or six 1.0-
inch hot swappable drives, one combination 3.5-inch floppy and IDE CD-
ROM, and one 5.25-inch half height removable media bay. The combination
CD-ROM and diskette drive connect to the SAF-TE transition module
attached on the system just to the rear of the combination unit. For more
information about the storage subsystem, refer to Chapter 7, “Using the
Storage Subsystems”.
Removable Bay SCSI Device
Whenever you install another SCSI device in the removable media bay area,
you must assign it a unique SCSI ID number. Otherwise, the system will not
recognize the device. Use the SCSI cable for connecting the drive to the SCSI
controller.
To install a drive in the spare bay, complete the following procedure.
1. Install the drive into the drive holder and secure it with four screws (two
on each side).
2. Install the drive holder into the system and secure it with four screws
(two on the top and two on the bottom).
3. Plug in one end of the SCSI cable to the SymBIOS adapter 895 card
located in PCI slot 2 (the cable must be 3 Meters).
4. Plug in the other end of the SCSI cable to the SCSI connection on the
rear of the storage backplane.
- AlphaServer DS20E 1
- AlphaStation DS20E 1
- Contents 3
- Chapter 2 4
- Chapter 3 4
- Chapter 4 5
- Chapter 5 5
- Chapter 6 5
- Chapter 7 5
- Chapter 8 6
- Chapter 9 6
- Chapter 10 7
- Chapter 11 7
- Appendix A 8
- Appendix C 8
- Appendix D 8
- List of Figures and Examples 9
- List of Tables 11
- About This Guide 13
- Symbols in Text 14
- Symbols on Equipment 14
- Rack Stability 15
- Getting Help 15
- Compaq Website 16
- Compaq Authorized Reseller 16
- System Overview 17
- System Introduction 18
- System Overview 1-3 19
- System Architecture 20
- System Features 22
- System Overview 1-7 23
- Table 1-1 23
- System Components 24
- Table 1-2 25
- System Parts 25
- System Features Module 26
- Table 1-3 27
- SFM Key Features 27
- SFM Switch Pack 28
- SFM Status LEDs 29
- System Fan Configuration 30
- Cover Interlock 30
- Processor Modules 31
- Table 1-5 32
- Typical SDRAM Configurations 32
- Hard Disk Drive Storage 34
- Power Supplies 35
- 2-Way Combination Module 36
- Operator Control Panel 37
- Table 1-6 38
- Control Panel Functions 38
- Table 1-7 38
- System Power LED Indicator 38
- Figure 1-12. Diagnostic LEDs 39
- Rear Panel 40
- Table 1-8 41
- Storage Device LEDs 42
- Table 1-9 43
- ❶ and the 44
- ❷ and FDD drive ❸ 44
- User Interface 45
- Console Terminal 46
- System Options 47
- External Options 48
- Ordering Options 48
- Installing the Pedestal 49
- Selecting a System Location 50
- Power Requirements 51
- Shipment Box 52
- Installing the System 53
- Table 2-1 54
- System Cable Connections 54
- Locking Your System 55
- will stick out past the 61
- ❺. To attach the front 62
- CAUTION: 64
- Connecting the Cables 66
- Installation 67
- Table 3-1 67
- Table 3-2 69
- Accessories List 69
- ❷ and continuing to pull 71
- Preparing the Rack 74
- Attaching Slides Brackets 75
- Stabilizing the Rack 76
- CAT0157A 78
- Dressing the Cables 82
- Attaching the Front Bezel 83
- Tru64 UNIX Systems 88
- OpenVMS Systems 89
- Table 4-1 90
- OpenVMS Boot Flag Settings 90
- Booting Tru64 UNIX 93
- 3. Install the boot medium 94
- Booting OpenVMS 99
- 5. Install the boot medium 100
- Powering Off the System 104
- Booting Linux 105
- Reconfiguring the System 109
- Memory Configuration 111
- Table 5-1 112
- Network Configuration 113
- ISA Options 114
- PCI Option Modules 117
- Table 5-2 118
- Updating the Firmware 119
- Using the AlphaBIOS 121
- AlphaPowered 122
- PK-0916-96 123
- Keyboard Conventions and Help 124
- Terminal 125
- Upgrading AlphaBIOS 126
- (Updating Firmware) 126
- Using the AlphaBIOS 6-7 127
- 6-8 DS20E Reference Guide 128
- Using the AlphaBIOS 6-9 129
- Utilities 130
- Using the Storage Subsystems 133
- Storage Subsystem Overview 134
- Table 7–1 135
- Table 7-2 136
- SCSI Bus Controller 137
- Disk Drive Configuration 138
- Backplane Connector 139
- Slot No. SCSI ID 139
- 7-8 DS20E Reference Guide 140
- Hot Swap 141
- Drive Carriers 142
- Removing the Drive Carriers 143
- DVA00032 143
- Drive Status LEDs 144
- Table 7– 5 145
- LED Status 145
- Installing Drive Carriers 146
- Removing 147
- ■ Single 4-slot subsystem 148
- ■ Single 6-slot subsystem 148
- Backplane 149
- Multimode SCSI Termination 151
- Combination CD-ROM and 151
- Floppy Drive 151
- Removing and Replacing a 152
- Combination Drive 152
- Spare Removable Media Bay 153
- External SCSI Expansion 155
- Installing Components 157
- Components 158
- Before You Begin Removal 159
- 1. Remove the bezel 160
- 3. Remove the panel 160
- 2. Slide the panel forward 161
- 3. Replace the screw 161
- Installing a Processor Module 163
- 8-8 DS20E Reference Guide 164
- Table 8-1 167
- Memory Bank Location 167
- To Remove a Memory DIMM 168
- To Install a Memory DIMM 169
- Configuring an Option Module 170
- Network Interface Module 170
- To Install an Option Module 172
- CAT0037 173
- Installing Storage Devices 174
- Removable Bay SCSI Device 174
- Installing Components 8-19 175
- 8-20 DS20E Reference Guide 176
- Troubleshooting 177
- Troubleshooting Overview 178
- System Error Beep Codes 179
- Power Problems 180
- Overheating Problems 181
- Boot Problems 182
- Table 9-5 183
- Hot-Swap Drive Status LEDs 183
- PCI Bus Problems 184
- Monitor and Terminal Problems 185
- Keyboard and Mouse Problems 186
- Printer Problems 186
- Managing the System Remotely 187
- RMC Overview 188
- First-Time Setup 189
- Dialing In and Invoking RMC 190
- RMC> hangup 191
- RMC Commands 193
- Command Conventions 194
- *** ERROR *** 198
- Table 10-2 199
- RMC Status Command Fields 199
- Using the RMC Switch Pack 200
- Uses of the Switch Pack 201
- Changing a Switch Setting 202
- Troubleshooting Guide 204
- Modem Dialog Details 205
- Using the SRM Console 207
- Invoking the SRM Console 209
- Command Summary 210
- Using the SRM Console 11-5 211
- Table 11-1 211
- Table 11-2 212
- Table 11-3 213
- Using the SRM Console 11-9 215
- [controller_name] 218
- Table 11-4 219
- Device Naming convention 219
- Table 11-5 219
- PCI Address Assignments 219
- P00>>> show version 222
- P00>>> 222
- Creating a Power-Up Script 223
- Editing the Nvram Script 224
- Booting the Operating System 225
- Configuring the System 227
- Using the SRM Console 11-23 229
- Configuring the ISA Bus 230
- Using the SRM Console 11-25 231
- Testing the System 233
- Making the System Secure 235
- Secure Mode Functions 236
- Example 11-16. Login Command 238
- 1. Enter the login command: 239
- Stopping and Starting CPUs 241
- Updating Firmware 243
- Example 11-19. Lfu Command 244
- Forcing a System Crash Dump 245
- Using Environment Variables 246
- Depositing and Examining Data 249
- Using the SRM Console 11-45 251
- Reading a File 253
- Initializing the System 254
- Finding Help 256
- Environment Variable Summary 257
- Table 11-6 258
- Table 11-7 261
- (Français) 264
- Enables PCI parity checking 267
- Disables PCI parity checking 267
- 1 (default) 268
- tt_allow_login 269
- Regulatory Compliance Notices 271
- Class A Equipment 272
- Modifications 274
- European Union Notice 275
- Safety Interlocks 276
- Australian Notice 276
- Laser Devices 276
- Laser Safety Warnings 277
- Laser Product Label 277
- Battery Replacement Notice 278
- Mouse Compliance Statement 279
- Appendix B 281
- Grounding Methods 282
- Power Cord Requirements 283
- Country-Specific Requirements 284
- Power Cord Requirements C-3 285
- System Specifications 287
- Rackmount 288
- Rackmount Cabinet 288
- Environmental Specifications 289
- Electrical Specifications 290
- System Specifications D-5 291
- Acoustical Data 292
Související produkty a manuály pro Barebones pro PC / pracovní stanice Compaq DS20E - AlphaStation - 1 GB RAM
Barebones pro PC / pracovní stanice Compaq ProLiant DL380 G4 with MSA500 Uživatelský manuál
(2 stránky)
(2 stránky)
Barebones pro PC / pracovní stanice Compaq DL580 - ProLiant - 1 GB RAM Uživatelská příručka
(24 stránky)
(24 stránky)
Barebones pro PC / pracovní stanice Compaq 8450 - PhotoSmart Color Inkjet Printer Uživatelský manuál
(4 stránky)
(4 stránky)
Barebones pro PC / pracovní stanice Compaq Presario SR2000 - Desktop PC Uživatelský manuál
(28 stránky)
(28 stránky)
Barebones pro PC / pracovní stanice Compaq Deskpro 4000 - Desktop PC Uživatelský manuál
(15 stránky)
(15 stránky)
Barebones pro PC / pracovní stanice Compaq 356110-004 - Deskpro EP - 6400X Model 10000 CDS Uživatelský manuál
(24 stránky)
(24 stránky)
(40 stránky)
Barebones pro PC / pracovní stanice Compaq Compaq Presario,Presario 8090 Uživatelský manuál
(2 stránky)
(2 stránky)
Barebones pro PC / pracovní stanice Compaq dc72 - Blade Workstation Client Uživatelský manuál
(51 stránky)
(51 stránky)
Barebones pro PC / pracovní stanice Compaq Presario Presario MyMovieSTUDIO Uživatelský manuál
(82 stránky)
(82 stránky)
Barebones pro PC / pracovní stanice Compaq ProLiant SL170z - G6 Server Uživatelský manuál
(8 stránky)
(8 stránky)
Barebones pro PC / pracovní stanice Compaq Xw8400 - Workstation - 4 GB RAM Průvodce nastavením
(44 stránky)
(44 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.039 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce