Compaq Compaq Portable II Průvodce řešením problémů stáhnout pdf (Strana 99)

To replace the mass storage device subassembly, reverse steps 7 and 8.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

CAUTION

When replacing the mass storage device subassembly, be sure that the cables do

not interfere with the mass storage device enclosure.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

Reconnect the cables, listed in step 5, to the system board.

To replace the bezel and rear panel, reverse steps 1 through 4.

Chapter 8.17 Fixed Disk Drive

To remove the fixed disk drive assembly:

1. Complete the preparation procedure (see Section 8.2).

2. Remove the rear panel (see Section 8.4).

3. Remove the mass storage device subassembly (see Section 8.12).

4. Locate the fixed disk drive (Figure 8-43) mounted in the rear position of

the mass storage device subassembly (Drive Position 2).

5. Disconnect the fixed disk drive power and data cables from the fixed disk

drive (Figure 8-44).

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 165 166

Žádné komentáře

Compaq Compaq Portable II Průvodce řešením problémů Strana 99