Compaq Compaq Portable II Průvodce řešením problémů stáhnout pdf (Strana 104)

Chapter 8.19 Power Supply

To remove the power supply:

1. Complete the preparation procedure (see Section 8.2).

2. Remove the rear panel (see Section 8.4).

3. Remove the interface connector cover, if installed (see Section 8.5).

4. Remove the 32 bit memory/modem interface board, if installed (see

Section 8.8).

5. Remove the system board cover (see Section 8.6).

6. Remove the microprocessor cover (see Section 8.7).

7. Remove the system board (see Section 8-14).

8. Disconnect the plasma display power connector from the power supply

(Figure 8-50).

9. Locate the power supply shown in Figure 8-51.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 165 166

Žádné komentáře

Compaq Compaq Portable II Průvodce řešením problémů Strana 104