Compaq StorageWorks 1000 - Modular Smart Array Servisní příručka stáhnout pdf (Strana 67)

Determining wh

ether a component is hot-pluggable

Before removin

g any serviceable part, determine whether the part is hot-pluggable or non-hot-pluggable.

• If the component is hot-pluggable, a power shutdown of the device is not required for replacement

of the part.

• If the component is not hot-pluggable, the device must be powered down.

CAUTION:

Be sure the rep

lacement is available before removing a component or blanking panel from the chassis.

Open slots dr

amatically impact airﬂow and cooling within the enclosure.

Table 3 Component hot-pluggability

Component

Hot-pluggable Non hot-pluggable

Redundant power supply/fan assembly

MSA array controller

(dual-controller conﬁgurations)

Fibre Channel I/O module

(dual-controller conﬁgurations)

SCSI I/O module

MSA chassis

Power switch module

MSA array controller

(single-controller conﬁgurations)

Fibre Channel I/O module

(single-controller conﬁgurations)

* Before removing one of the two controllers or Fibre Channel I/O modules in an operational dual-controller

MSA, the controller being removed must ﬁrst be disabled. For more information, see Replacing the controller,

controller cache, or controller battery .

maintenance and service guide

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 121 122

Žádné komentáře

Compaq StorageWorks 1000 - Modular Smart Array Servisní příručka Strana 67