Compaq StorageWorks 6000 - Virtual Library System Uživatelská příručka Strana 222
- Strana / 358
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
DescriptionItem
Hard drive blank6
Hard drive 27
Hard drive 18
Front Panel LEDs and Buttons
StatusDescriptionItem
Green = System is on.
Amber = System is shut down, but power is still
applied.
Off = Power cord is not attached, power supply
failure has occurred, no power supplies are
installed, facility power is not available, or
disconnected power button cable.
Power On/Standby button and system power
LED
1
Blue = Identification is activated.
Flashing blue = System is being remotely
managed.
Off = Identification is deactivated.
UID button/LED2
Green = System health is normal.
Amber = System health is degraded. To identify
the component in a degraded state, refer to HP
Systems Insight Display LEDs and Internal Health
LED Combinations.
Red = System health is critical. To identify the
component in a critical state, refer to HP Systems
Insight Display LEDs and Internal Health LED
Combinations.
Off = System health is normal (when in standby
mode).
Internal health LED3
Green = Power supply health is normal.
Amber = Power redundancy failure occurred.
Off = Power supply health is normal when in
standby mode.
External health LED (power supply)4
Component Identification222
- System User Guide 1
- Acknowledgments 2
- Warranty 2
- Revision History 2
- Contents 3
- 1 Introduction 19
- VLS6200–series 20
- VLS6500–series 21
- VLS6600–series 23
- VLS6800–series 24
- Disk array 02 25
- Disk array 13 25
- Disk array 24 25
- Disk array 35 25
- Capacity 27
- Data compression (2:1) 27
- Disk arraysModel 27
- Introduction28 28
- 2 Hardware Installation 29
- Unpacking 30
- Rack Planning Resources 30
- Rack Requirements 31
- Rack Warnings 31
- Disk Array Shipping Carton 35
- Rack Mounting Requirements 35
- WARNING! 39
- Hardware Installation40 40
- Hardware Installation42 42
- Install Rails in the Rack 44
- Attach Rails to the Node 45
- Install Appliance in Rack 45
- Install Appliance in the Rack 48
- Hardware Installation50 50
- Hardware Installation52 52
- Hardware Installation54 54
- FC host port 01 55
- FC host port 12 55
- FC host port 23 55
- FC host port 34 55
- 10/100/1000 NIC 1 connector5 55
- Installing VLS6800 Cables 60
- Hardware Installation64 64
- 3 Storage Configuration 65
- Removing Arrays 68
- Managing Storage Pools 68
- Rebuilding the Storage Pool 69
- Storage Configuration70 70
- Storage Configuration72 72
- 4 Automigration/Replication 73
- Echo Copy Concepts 74
- Smart Copy Concepts 75
- Replication Concepts 75
- Tape Initialization 76
- Automigration/Replication78 78
- Managing a SAN Library 79
- Automigration/Replication80 80
- Echo Copy Pool Operations 81
- Creating an Echo Copy Pool 82
- Automigration/Replication84 84
- Creating Virtual Tapes 85
- Automigration/Replication86 86
- Restarting a Broken Mirror 88
- Smart Copy Pool Operations 89
- Automigration/Replication90 90
- Editing Copy Pools 91
- Automigration/Replication92 92
- Deleting a Copy Pool 94
- Advanced Search for Slots 98
- Forcing a Replication Job 99
- Automigration/Replication100 100
- Editing the Management URL 102
- Automigration/Replication104 104
- Stopping a Tape Export 106
- Automigration/Replication108 108
- Automigration/Replication110 110
- Cartridge Status 111
- Cartridge Details 112
- Cartridge Summary 112
- Viewing the Job History 114
- Viewing the Job Summary 115
- Configuring the GUI Displays 115
- Automigration/Replication116 116
- 5 Deduplication 117
- Considerations 118
- Installing the Firmware 118
- Deduplication120 120
- Deduplication Summary 121
- Deduplication Backup Report 121
- Deduplication122 122
- Deduplication System Capacity 123
- Deduplication124 124
- 6 Operation 125
- StatusDescriptionItem 127
- Rebooting the System 129
- Powering Off the System 130
- Operation132 132
- 7 User Interfaces 133
- Window Regions 134
- User Interfaces136 136
- Restarting Command View VLS 137
- User Interfaces138 138
- Opening a Serial Session 139
- Closing a Serial Session 139
- User Interfaces140 140
- 8 Configuration 141
- Configuration142 142
- Setting the User Preferences 146
- Managing Oversubscription 148
- Shutdown at 98% Capacity 149
- Managing Virtual Device LUNs 150
- LUN Masking 151
- LUN Mapping 152
- LUN Mapping (v3.x) 153
- Configuration154 154
- Configuration156 156
- LUN Mapping (v2.x) 158
- Dual Port Virtual Devices 159
- Creating a Virtual Library 160
- Creating Tape Drives 162
- Creating Cartridges 164
- Configuration166 166
- Destroying a Virtual Library 167
- Destroying a Tape Drive 167
- Deleting Cartridges 168
- Moving Cartridges 169
- Configuration170 170
- 9 Management 171
- Freeing up Storage Space 172
- Updating the Firmware 173
- Saving Configuration Settings 174
- 10 Monitoring 175
- Notification Alerts 176
- Command View VLS 177
- E-mail Notification 177
- Edit the Email Settings 178
- SNMP Notification 179
- Editing the SNMP Settings 180
- SMI-S Support 181
- Trace Log Files 182
- Exporting CSV Data 183
- Performance History Tab 184
- Current Status 185
- Performance History 185
- Logical Capacity 186
- Physical Capacity 187
- SAN Health 187
- Monitoring188 188
- Workload Assessment 189
- Replication History 190
- Receiving Automated Reports 190
- Stress Testing Hard Disks 192
- Monitoring194 194
- Log File Fields 195
- Monitoring196 196
- Monitoring198 198
- 11 CLI Command Set 199
- VLS Commands 200
- Configuration Commands 202
- Management Commands 209
- Monitoring Commands 210
- 12 Component Identification 213
- Front Panel LEDs and Buttons 214
- Rear Panel Components 215
- Rear Panel LEDs and Buttons 216
- System Board Components 217
- System Board LEDs 218
- Fan Module Locations 220
- Processor Zone Fan Module LED 221
- Front Panel Components 221
- Internal USB connector15 226
- System battery16 226
- PCI riser board connector 217 226
- PCI riser board connector 118 226
- Component Identification226 226
- StatusInternal health 228
- LED color 228
- HP Systems In 228
- Hard Drive LEDs 229
- Hard Drive LED Combinations 229
- Fan Locations 230
- FBDIMM Slots 236
- DescriptionItem 246
- ActionStatusDescriptionItem 247
- Front Panel LEDs 251
- Component Identification254 254
- 13 Component Replacement 255
- Preparation Procedures 256
- Component Replacement258 258
- Component Replacement260 260
- Component Replacement262 262
- Component Replacement264 264
- SATA Hard Drive 265
- CD-ROM Drive 266
- Power Supply 267
- Power Supply Zone Fan Module 268
- Processor Zone Fan Module 269
- Component Replacement270 270
- DVD-CD Drive 272
- Component Replacement274 274
- Fan Module 275
- 4. To remove fan module 1: 276
- Component Replacement280 280
- Component Replacement282 282
- SCSI Hard Drive 284
- Diskette Drive 286
- Component Replacement288 288
- Processor Memory Board 289
- Processor Power Module 290
- Processor 292
- Hard Drive 294
- Controller Module 297
- Component Replacement298 298
- 14 Disaster Recovery 299
- Disaster Recovery300 300
- Warm Failover 301
- Disaster Recovery302 302
- Related Information 303
- Rack Stability 305
- Contacting HP 306
- Subscription Service 306
- Customer Self Repair 307
- Product Warranties 307
- Documentation Feedback 308
- A Troubleshooting 309
- Deduplication Issues 317
- B Specifications 319
- VLS6200 Node 320
- VLS6600 Node 321
- VLS6800 Node 322
- VLS6000–series Disk Array 323
- Environmental Specifications 323
- Specifications324 324
- FCC rating label 325
- Modification 326
- Class A Equipment 326
- European Union Notice 327
- Japanese Notices 327
- Korean Notices 328
- Taiwanese Notices 328
- Laser Compliance Notices 329
- French Laser Notice 330
- German Laser Notice 330
- Italian Laser Notice 330
- Recycling Notices 331
- Bulgarian Notice 332
- Czech Notice 332
- Danish Notice 332
- Dutch Notice 332
- Estonian Notice 333
- Finnish Notice 333
- French Notice 333
- German Notice 333
- Greek Notice 334
- Hungarian Notice 334
- Italian Notice 334
- Latvian Notice 334
- Lithuanian Notice 335
- Polish Notice 335
- Portuguese Notice 335
- Romanian Notice 335
- Slovak Notice 336
- Spanish Notice 336
- Swedish Notice 336
- Turkish Notice 336
- Battery Replacement Notices 337
- French Battery Notice 338
- German Battery Notice 338
- Italian Battery Notice 339
- Japanese Battery Notice 339
- Spanish Battery Notice 340
- Glossary 341
- Glossary342 342
- Glossary344 344
- Glossary346 346
Související produkty a manuály pro Software Compaq StorageWorks 6000 - Virtual Library System
Software Compaq Aero 1520 Uživatelská příručka
(38 stránky)
(38 stránky)
Software Compaq Tru64 UNIX Instalační příručka
(180 stránky)
(180 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.077 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce