Compaq Reliable Transaction Router Instalační příručka stáhnout pdf (Strana 46)

Full Installation on Compaq Tru64 UNIX

5.1 Preparing for RTR Installation on Compaq Tru64 UNIX

3. Specify in the

/etc/fstab

ﬁle that one or more of the newly created

directories are mount points to new disk partitions where there is

additional space.

4. Enter the

mount -a

command so that the new mount points take effect.

5.1.5 Installing from Media or Using RIS

Someone from your site must perform at least one RTR installation from the

distribution medium. Your site system manager can then decide whether

or not to make a RTR distribution kit available online so that subsequent

installations of RTR can use the Remote Installation Service (RIS). For

information on extracting RTR subsets to a RIS distribution area, see the

Guide to Sharing Software on a Local Area Network.

If you expect to use RTR subsets from the RIS area of a remote system for

installation on your local system, ﬁrst check with your site system manager to

ensure that:

• A RTR network kit is available for use.

• Your system is registered as a RIS client.

If RTR subsets are available to you on a RIS server system, you must know the

name of that system.

For more information on installing RTR from a RIS distribution area, see

Section 5.2.1.2.

5.1.6 Backing Up Your System Disk

Compaq recommends that you back up your system disk before installing any

software. For information about backing up your system disk, see the Tru64

UNIX system documentation.

5.1.7 Stopping the Installation

To stop the installation procedure at any time, press Ctrl/C. You must then

delete ﬁles created up to this point interactively. The directories and ﬁles

created during the RTR installation are listed in the following ﬁle (on your

CD-ROM):

/rtr40/kit/instctrl/rtrbase400.inv

5–6 Full Installation on Compaq Tru64 UNIX

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Žádné komentáře

Compaq Reliable Transaction Router Instalační příručka Strana 46