Compaq HSZ80 Instalační příručka stáhnout pdf (Strana 12)

COMPAQ StorageWorks Upgrading From an HSZ70 to an HSG80 Array Controller

Page 12 EK-HSG80-UP. B01

9.0 Installing the HSG80 Components

Use the following steps to install the HSG80 components:

CAUTION

ESD can easily damage a cache module or controller. Wear a

snug-fitting, grounded ESD wrist strap.

Make sure you align the cache module and controller in the

appropriate guide rails. If you do not align the modules

correctly, damage to the backplane can occur.

CAUTION

The ECB must be disabled—the status light is not lit or is not

blinking—before connecting the ECB cable to the cache

module. Failure to disable the ECB could result in ECB

damage.

Important: If performing a dual-redundant controller upgrade, do ONLY the upper controller at

this time.

1. Insert the new cache module into left slot A, and engage its retaining levers.

2. Connect the new ECB cable to the new, Cache Module A and the ECB.

3. Make sure the program card is not in the controller and insert the new controller into the top

slot, A, and engage its retaining levers.

4. Connect the host fibre cables to Controller A. One or two host fibre cables may be attached

depending upon the configuration.

5. Connect a PC or terminal to the controller’s maintenance port.

6. Power-on all of the HSG80 enclosures. Wait for the indicator lights on the EMU to turn off.

7. Using a pen or small screwdriver, press and hold

PORT BUTTON 6 on the HSG80 Operator

Control Panel and insert the program card. Wait until the

RESET button/LED starts blinking,

then release

PORT BUTTON 6. If the Operator Control Panel LEDs do not begin to flash when

the program card is inserted, continue to hold OCP

PORT BUTTON 6, then eject and re-insert

the program card.

8. Silence the EMU alarm by depressing the yellow push button on the EMU.

9. Automatic reboot takes place and if saved the previous configuration is restored. This takes

several minutes—please be patient. If the configuration is restored the CLI displays:

NOTE

Saved configuration restored. Rebooting with new

configuration.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Žádné komentáře

Compaq HSZ80 Instalační příručka Strana 12